JVC RDN1 Portable CD Player User Manual


 
ID3 ON ID3 OFF
CAUTION: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage,
locate the apparatus as follows:
Front: No obstructions and open spacing.
Sides/Top/Back: No obstructions should be placed in the
areas indicated by the dimensions in the illustration.
Bottom: Place on the level surface. Maintain an adequate air
path for ventilation by placing on a stand with a height of
10 cm or more.
ATTENTION: Aération correcte
Pour prévenir tout risque de décharge électrique ou d’incendie
et éviter toute détérioration, installez l’appareil de la manière
suivante:
Avant: Bien dégagé de tout objet.
Flancs/ Dessus/ Arrière: Aucun obstacle ne doit être
placé dans les zones indiquées par les dimensions dans
l’illustration.
Dessous: Posez l’appareil sur une surface plane et
horizontale. Veillez à ce que sa ventilation correcte puisse
se faire en le plaçant sur un support d’au moins dix
centimètres de hauter.
1.
2.
3.
1.
2.
3.
Side view/Côté
Front view/Face
Microsoft and Windows Media are either registered
trademarks or trademarks of Microsoft Corporation in
the United States and/or other countries.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
“Made for iPod” means that an electronic accessory
has been designed to connect specifically to iPod and
has been certified by the developer to meet Apple
performance standards.
Apple is not responsible for the operation of this device
or its compliance with safety and regulatory standards.
ENGLISH
Thank you for purchasing a JVC product.
LVT2130-002B [J, C, B, US, A, UX]
0910TMMMDWMTS
©2010 Victor Company of Japan, Limited
SLEEP 10 SLEEP 20 SLEEP 30
SLEEP 90
OFF
HBS
ROCK
POP CLASSIC
JAZZ
File Title
ArtistAlbum
Group
RD-N1
RD-N1W
For customer use:
Enter below the Model No. and Serial No. which are
located either on the rear, bottom or side of the cabinet.
Retain this information for future reference.
Model No.
Serial No.
For USA-California Only
This product contains a CR Coin Cell Lithium Battery
which contains Perchlorate Material—special handling
may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
1
Sound Mode
To select the sound mode suitable for your favorite
music.
Setting the clock
You can set the clock only when the System is turned
off (on standby.)
1
If you have already set the clock before, press and
hold CLOCK until the clock is flashing.
2 Adjust the hour and minute.
The clock may gain or lose 1 to 2 minutes per month.
You may need to readjust the clock periodically.
Compatible iPod models
iPod model Audio
iPod nano
iPod nano (2nd Generation)
iPod nano (3rd Generation)
iPod nano (4th Generation)
iPod nano (5th Generation)
iPod mini
iPod mini (2nd Generation)
iPod (4th Generation)
iPod classic
iPod photo (4th Generation)
iPod video (5th Generation)
iPod touch
iPod touch (2nd Generation and Fall ‘09)
If iPod does not play correctly, update iPod software to the
latest version.
For details about updating iPod, check on the Apple web
site <http://www.apple.com>.
Maintenance
To get the best performance of the System, keep your discs
and the mechanism clean.
Handling discs
Remove the disc from its case by holding it at the edge
while pressing the center hole lightly.
Do not touch the shiny surface of the disc, or bend the
disc.
Put the disc back in its case after use.
Be careful not to scratch the surface of the disc when
placing it back in its case.
Avoid exposure to direct sunlight, temperature extremes,
and moisture.
To clean the disc:
Wipe the disc with a soft cloth in a straight line from center
to edge.
Cleaning the System
Stains should be wiped off with a soft cloth. If the System
is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe
clean with a dry cloth.
Since the System may deteriorate in quality, become
damaged or get its paint peeled off, be careful about the
following:
DO NOT wipe it hard.
DO NOT wipe it with thinner or benzine.
DO NOT apply any volatile substances such as
insecticides to it.
DO NOT allow any rubber or plastic to remain in contact
for a long time.
CD PORTABLE SYSTEM
Prepare the remote control
When you use the remote control for the first time, pull out the insulation sheet.
To replace the battery in the remote control
Supplied accessories
After unpacking, check to make sure that you have all
the following items:
Remote control (× 1)
Lithium coin battery CR2025 (× 1)
The battery has been installed in the remote
control when shipped from the factory.
FM antenna (× 1)
AC plug adaptor (× 1) (Not supplied for USA,
Canadian, European, Australian and Saudi Arabian
models.)
If anything is missing, consult your dealer immediately.
Notes on the power cord
When you go away for an extended period of time,
remove the plug from the wall outlet.
When unplugging the System from the wall outlet,
always pull the plug, not the power cord.
Do not handle the power cord with wet hands.
Disconnect the power cord before cleaning the System or
moving the System.
Do not alter, twist or pull the power cord, or put anything
heavy on it, which may cause fire, electric shock, or other
accidents.
Avoid moisture, water, dust, and high temperatures
Do not place the System in moist or dusty places.
If water gets inside the System, turn off the power and
remove the plug from the wall outlet, then consult your
dealer. Using the System in this state may cause a fire or
electrical shock.
Do not expose the System to direct sunlight or place it
near a heating device.
Lithium coin battery
(product number: CR2025)
NOTES:
Store the battery in a place where children cannot reach. If a child accidentally
swallows the battery, consult a doctor immediately.
To prevent the battery from overheating, cracking, or starting a fire:
Do not recharge, short, disassemble or heat the battery or dispose of it in a
fire.
Do not leave the battery with other metallic materials.
Wrap the battery with tape and insulate when throwing away or saving it.
Do not poke the battery with tweezers or similar tools.
Dispose of battery in the proper manner, according to federal, state, and local
regulations.
The battery (battery pack or battery installed) shall not be exposed to excessive
heat source such as sunshine, fire or the like.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
Getting started
For better FM reception
Disconnect the supplied FM antenna, and connect to an outdoor FM antenna (not supplied)
using a 75 Ω wire with coaxial type connector (IEC or DIN45325).
To a wall outlet
FM antenna (supplied): Extend it so that you can obtain the best reception.
NOTES:
Make sure the antenna conductors do not touch any other terminals, connecting cords
or the power cord. Also, keep the antennas away from metallic parts of the System,
connecting cords, and the AC power cord. Otherwise, it could cause poor reception.
Sound and other adjustments
Precautions
Connections Do not connect the AC power cord until all other connections have been made.
In this manual...
The remote control buttons are used for explaining the
operations unless mentioned otherwise. However, if the
System has the same or similar button names, they can
also be used for the operations.
“File” and “track” are used interchangeably.
All the illustrations of the display used as examples are
from the European models.
Amplifier section
Output Power: 6 W (3 W + 3 W) at 3 Ω (10% THD)
Audio Input: AUDIO IN: Stereo mini (ø 3.5 mm)
250 mV/47 kΩ
Digital input: USB MEMORY
Tuner
FM tuning range: 87.50 MHz – 108.00 MHz
Disc player
Dynamic range: 80 dB
Wow and flutter: Immeasurable
USB
USB specification: Compatible with USB 2.0 Full Speed
Compatible device: Mass storage class
Compatible system: FAT16, FAT32
Output power: DC 5 V
500 mA
iPod
Output power: DC 5 V
500 mA
General
Speaker type: Bass-Reflex type
Speaker unit: 9 cm (3–9/16 inches) x 2
Speaker impedance: 3 Ω
Power requirements:
For USA and Canadian models AC 120 V / 60 Hz
For European models AC 230 V / 50 Hz
For Australian models AC 240 V / 50 Hz
For other models AC 110 V – 127 V / 220 V – 240 V
adjustable with voltage selector, 50/60 Hz
Power consumption: 35 W (at operation)
1.00 W or less (on standby)
Dimensions (approx.): 400 mm × 141 mm × 211 mm
(15–3/4 inches × 5–9/16 inches × 8–5/16 inches)
(W × H × D)
Mass (approx.): 3.3 kg (7.3 lbs)
Troubleshooting
If you are having a problem with your System, check this list for a possible solution before calling for service.
General
Power does not come on. \ Power plug is not inserted securely. Plug it in securely.
Adjustments or settings are suddenly
canceled before you finish.
\ There is a time limit. Start the procedure again.
Unable to operate the System from the
remote control.
\ The path between the remote control and the remote sensor on the
System is blocked.
\ The battery is exhausted.
No sound is heard. \ Headphones are connected.
FM radio
Hard to listen to broadcasts because of
noise.
\ Antenna connection is incorrect or loose.
\ The FM antenna is not properly extended and positioned.
\ Electrostatic discharge from your body may cause noise. If this
happens, turn the System off then on again.
iPod
The iPod does not play, but “IPOD”
appears on the display.
\ The iPod battery is low or exhausted. Charge the iPod battery.
Disc/USB
The disc/USB mass storage class device
does not play.
\ The disc is placed upside down. Place the disc with the label side
facing up.
\ The disc is recorded using “packet writing (UDF file system).” It cannot
be played.
\ The USB mass storage class device is not connected properly.
“NO SONG” appears on the display. \ MP3/WMA files are not recorded on the disc or USB mass storage class
device.
ID3 Tag on an MP3 file cannot be shown. \ There are two types of ID3 Tag—Version 1 and Version 2. This System
can only show ID3 Tag Version 1.
Groups and tracks are not played back as
you expect.
\ Playing order is determined when the groups and tracks are recorded.
It depends on the writing application.
The disc/USB mass storage class device
sound is discontinuous.
\ The disc is scratched or dirty.
\ MP3/WMA files have not been properly recorded onto the USB mass
storage class device.
Sound from the USB mass storage class
device is interrupted.
\ Noise and static electricity may stop the sound. In this case, disconnect
and connect the USB mass storage class device again after turning off
the System.
The disc tray does not open or close. \ The AC power cord is not plugged in.
\ Disc ejection is prohibited. “DISC LOCKED” appears (see “Prohibiting
disc ejection” in “Disc/USB” on page 2).
Recording
Unable to record onto a USB mass
storage class device.
\ The capacity of the USB mass storage class device is full.
\ The USB mass storage class device is write-protected.
If the System does not work correctly, disconnect the AC power cord from the wall outlet, wait for a while, then
connect the cord again.
JVC bears no responsibility for any loss of data in USB mass storage class device or iPod while using this System.
Initial settings
Playable disc/file types
This System can play back...
Audio CD and CD-R/CD-RW in Audio CD format
MP3/WMA files on a CD-R/CD-RW (ISO 9660 format) or
USB mass storage class device (maximum data transfer
rate: 2 Mbps)
This System cannot play “packet write” discs.
For MP3/WMA playback...
Some MP3/WMA files may not be played back due to
their recording conditions.
This System can play only discs of ISO 9660 Level 1 or
Level 2.
It is recommended to record each file at a sampling rate
of 44.1 kHz and at a data transfer rate of 128 kbps.
This System can recognize a total of 999 tracks and 99
groups.
This System can show the Tag data (version 1).
For playback of files on a USB mass storage class device...
You cannot play back files larger than 2 GB.
This System may not play back some USB mass storage
class devices and does not support DRM (Digital Rights
Management).
To check the current time while the System is turned
on
The time is displayed for a few seconds.
If there is a power failure
The clock loses its settings. You need to set the clock
again.
(Hold)
Display settings
Display information
To display ID3/WMA tag information
During playback of MP3/WMA...
ID3/WMA tag information is displayed automatically
as follows:
Sleep Timer
You can set Sleep Timer only when the System is turned
on.
1
2 Specify the time.
To check the remaining time until the System shuts
off, press and hold CLOCK.
Timer
(Hold)
Sound adjustments
Fade muting
To drop the volume in a moment
To restore the volume, press again or adjust the
volume.
Hyper Bass Sound (HBS)
To reinforce the bass sound
(Europe only)
Notes on installation
Select a place which is level, dry and neither too hot nor
too cold—between 5˚C and 35˚C (41°F and 95 °F).
Do not install the System in a place subject to vibrations.
Do not put heavy objects on the System.
To prevent malfunction or damage to the System
Do not insert any metallic objects, such as wires, hairpins,
coins, etc. into the System.
Do not block the vents.
There are no user-serviceable parts inside. If anything
goes wrong, unplug the power cord and consult your
dealer.
Supplied accessories
See “Supplied accessories” in “Getting started.”
Design and specifications are subject to change without
notice.
Specifications
When you replace the battery, place the
edge of the battery under the wire loop.
Wire loop
(No indication)
Canceled
INSTRUCTIONS
Canceled
Mains (AC) Line Instruction (Asia and Saudi Arabia only)
CAUTION for mains (AC) line
BEFORE PLUGGING IN, do check that your mains (AC) line
voltage corresponds with the position of the voltage selector
switch provided on the outside of this equipment and, if
different, reset the voltage selector switch, to prevent from a
damage or risk of fire/electric shock.
If the wall outlet does not match the AC plug, use the supplied AC plug adaptor.
(Not supplied for USA, Canadian, European, Australian and Saudi Arabian models.)
EN_RDN1[JCBUSAUX]REV_B_2nd.indd 1EN_RDN1[JCBUSAUX]REV_B_2nd.indd 1 10.7.28 0:56:57 PM10.7.28 0:56:57 PM