JVC HR-1080-PRO MP3 Player User Manual


 
JVC HR-1080-PRO Video Processor User Manual MKT-0027-UMN-1.002F
parameters, such as Output Resolution. Visual feedback for the adjustments of Setup Mode is
seen on the 24 x 2 LCD display, rather than on OSD of the main screen. Sensitive parameters
are placed in the Setup Menu so that an inadvertent key stroke with the IR remote does not cause
a change in a parameter that would be difficult to recover from. Table 1 lists the Setup
parameters and
Table 2 lists the output resolutions currently supported in the unit.
Table 1: Setup Parameters
Parameter Description
1
OUT = XXX ## Hz
Cycles through all of the available JVC HR-1080-PRO
output modes (see
Table 2 for a list of Output
Resolutions).
LCD Brightness = On (Off)
Turns On (Off) the 24 x 2 LCD Display during Operate
Mode
Output Sync = Free Run (Vadjust 1:1,
Vjam)
These settings enables to adjust the output sync:
Free Run – Establishes a precise output timeline
Vadjust 1:1 – Forces the output timeline to be frame locked
to the input by inserting or deleting entire lines of output
video
Vjam – Maintains frame lock by truncating final line of
output frame
BAUD = #####
Lets you choose a baud rate of 1200, 9600, 19200, 57600,
or 115000.
OSD Location = Input (Output)
The OSD may be located pre (Input side) or post (Output
side) scaling and keystone correction
PC Control = Active (Inactive)
Turns On (Off) the computer control capability
DHCP = On (Off)
Turns on Dynamic IP Address Selection
IP=aaa.bbb.ccc.ddd Select IP Address (selectable only if DHCP = Off)
DNS=aaa.bbb.ccc.ddd Select DNS Address (selectable only if DHCP = Off)
2
nd
DNS=aaa.bbb.ccc.ddd
Select Alternate DNS Address
(selectable only if DHCP = Off)
Gateway=aaa.bbb.ccc.ddd Select Gateway Address (selectable only if DHCP = Off)
SubMask=aaa.bbb.ccc.ddd Select SubNet Mask (selectable only if DHCP = Off)
Serial No = ###### Indicates the Serial # of JVC HR-1080-PRO unit
MAC = ## ## ## ## ## ## Indicates the MAC Address of JVC HR-1080-PRO unit
JVC Inc. Page 17
1
The default parameters configurations are highlighted in bold.