Filter
Top Products
13
Insignia NS-CLVR01 Clock Radio with Voice Command
www.insigniaproducts.com
To record a preset name
To record a preset name:
1 Press and hold the
/SOURCE button for two seconds to turn on
your clock radio.
2 Press the
/SOURCE button repeatedly to select the AM or FM
band.
3 Press PRESET repeatedly until you reach the station you want to
record.
4 Press the RECORD button. The clock radio will respond “Please
say the station name.”
5 Speak the name you want to set for that particular preset station,
for example “News Station.”
6 The clock radio responds “Please repeat station name.”
7 Speak the name again.
To confirm that the setting was successful, the clock radio will
reply, “Thank you. Station name recorded for station preset (__).”
The radio will then switch to radio mode.
Using manual buttons
Setting and using the alarm
You can also set the alarm using voice commands. See “Using voice
commands” on page 10.
To set the alarm:
1 Press and hold the ALARM 1 or ALARM 2 button (depending on
which alarm you want to set) until the display blinks
.
Note
• If the name is too similar to the name of other preset
stations set earlier, the clock will suggest that you choose
a different name by saying “The name is too similar to
existing station name, please choose a different name
and try again.”
• If the setting is not successful, the clock radio will state
“Training failure, please try again.” You are allowed two
tries.
NS-CLVR01_10-0138_MAN_ENG_V2.fm Page 13 Tuesday, February 2, 2010 3:04 PM