Filter
Top Products
Read these instructions carefully before using this product, and retain
them in a safe place for reference.
Features
To p
1 Handle 5 Function (RADIO/CD/AUX)
2 CD door 6 Power (ON/OFF)
3 Volume control 7 Tuning control
4 FM antenna 8 CD door open (push tab)
Back
1.5V x 8 UM 2 or
“C” size or LR14
+
-
+
-
+
-
+
-
+
-
+
-
+
-
+
-
1 AUX IN jack
2 Battery compartment
3 AC input
Quick Installation Guide
NS-B4111 CD Boombox
Front
1 Speaker 8 Speaker
2 CD play/pause button 9 Time set button
3 CD stop button 10 Display button
4 CD skip next button 11 Repeat button
5 CD track display 12 Random button
6 CD skip previous button 13 Standby button
7 AM/FM button
Setting up your CD player
Connecting AC power
1 Connect the provided AC power cord to the AC input socket on
the CD player.
2 Plug the cord into a household AC power socket.
Installing batteries
1 Insert eight C alkaline batteries (not included) into the battery
compartment as indicated by the diagram within the
compartment.
2 Securely close the battery compartment cover.
Notes: Battery power is used only when AC power is disconnected.
Replace all batteries at the same time with the same battery type.
Do not mix battery types.
When CD player is stored unused for a long time, remove the
batteries to prevent damage.
Setting the clock
1 Turn off your CD player, then press
TIME SET. The hour digits fl ash. Set
time under Standby mode.
2 Press or to adjust the hour,
then press TIME SET. The minute
digits fl ash.
3 Press or to adjust the minute,
then press TIME SET. The clock is set.
4 To view the clock, turn on your CD
player, then press DISPLAY.
NOTE: While the boombox is in standby mode running on battery
power, your batteries will continue to slowly drain, although
the clock’s time will be saved. To prevent battery drain, turn the
boombox completely off by sliding the power switch (although
your clock setting will be lost).
Using your CD player
Warning: Use of any controls, adjustments, or procedures other
than those specifi ed herein may result in hazardous radiation
exposure.
Using the radio
1 Slide the FUNCTION selector to RADIO, then press AM/FM to
select AM or FM mode.
2 Turn the TUNING control until you locate the station you want.
If you tune to an FM station broadcasting in stereo, the stereo
indicator turns on. “ST” will appear in the upper-right of the LCD
screen when stereo is on.
For optimum FM reception, make sure that the FM
(telescopic) antenna is fully extended and vertical.
For optimum AM reception, rotate the CD player to orient its
built-in antenna until you get the strongest signal.
Using the CD player
The CD player can play standard audio CDs and audio CDs created
on a computer’s CD-R/CD-RW drive.
1 Slide the FUNCTION selector to CD, then lift the CD door and
insert a CD with the label facing up. Make sure that the CD is
correctly mounted on the spindle and locked in place.
•
•
NS-B4111_09-0103_QSG_V2_EN.indd 1NS-B4111_09-0103_QSG_V2_EN.indd 1 3/4/2009 7:57:12 PM3/4/2009 7:57:12 PM