Filter
Top Products
PRESET FOR USE
19
PRESET FOR USE
Channel memory programming is NOT needed when connected to a cable box. You can program
the tuner to scan only the channels you receive in your area. See page 32 for channel
designations.
NOTE: You must use the remote control for this procedure.
AUTOMATIC CHANNEL PRESET (Without a Cable Box)
NOTES:
• Follow the steps below once. Repeat it only if there is a power failure or the VCR is unplugged for
more than 30 seconds. (In these cases, the programmed channels are erased.)
• You must follow the steps below before attempting to play or record a video tape. If you want to
play or record a video tape. If you want to play or record a video tape BEFORE programming the
tuner, you must first press the POWER button to turn off the VCR. Then, press the POWER button
again to turn it back on. To program the tuner again, see "CHANNEL PRESET AGAIN".
1 Plug in the VCR power cord ("--:--" flashes)
Plug the VCR power cord into a standard AC outlet.
2 Select channel 3 or 4 on the TV
Turn on the TV and set the TV channel to the same video output channel as located on the back
of the VCR. (CH3 or 4)
3 Turn on the VCR
Press the POWER button to turn on the VCR. "n
nn
n" appears on the display.