Filter
Top Products
Basic Operations
32
This VCR's indexing system is based on the VHS Standard Indexing System (VISS). The new
system may not recognize index marks on tapes recorded on older VCRs.
• If the VCR is in PLAY mode, press STOP.
• Press INDEX on the remote control. This brings up Set Go-To Time/Index Screen.
• Press REW or F.FWD to begin the index search.
The tape rewinds or fast-forwards until an index mark is detected.
When the VCR finds an index mark, it plays 15 seconds of the program that begins at that spot.
During this period, the words SCAN AND PLAY will be displayed on the bottom of your
screen.
• If this is the program you were looking for, press INDEX and the VCR will stop searching. Or
press PLAY, resume normal playback.
• If this is not the program you want, don't press anything. After 15 seconds, the VCR will move
to the next mark and play a part of that program. The VCR will continue searching until you
press INDEX again or PLAY reach the end of the tape.
When you find the program you want and press INDEX and the VCR returns to PLAY mode.
To stop the index search before an index mark is reached, press STOP.
If there are no index marks on the tape, the VCR will just rewind to beginning or fast forward to
the end.