Filter
Top Products
Getting Started (Initial Setup)
24
mark displays instead of the illogical number.
• If you press the wrong digit, exit the screen by pressing GUIDE and recall the screen to enter
the correct setup.
• The day of the week is set automatically.
More About Channel Selections
Your VCR is capable of receiving 68 broadcast TV channels (VHF 2-13, UHF 14-69) and 125
cable channels (CATV 1-125).
When you press 2 on the Initial Setup screen, the tuner automatically cycles through all available
channels in your area and places them in memory. This takes 2-3 minutes. You can watch the
progress on the VCR's display - when the channel numbers stop changing, programming is
complete. Only when the power goes out for more than 30 minutes do you need to preset the
channels again.
• In some areas channels cannot be switched when CATV1 is selected. Then, select CATV2 in
your Initial Setup screen.
• For convenience, the TV channel numbers should match those programmed into the VCR. If
your TV has automatic channel programming, set it on the same mode - ANT, CATV1, or
CATV2 - and let it reprogram to match the VCR.
Once channels are preset, you can use the up and down CHANNEL buttons to move through the
active channels or you can press the number buttons to move quickly between channels that are
far apart.
Removing Channels
You may not want to keep all the stations the auto-programmer selects, since you may prefer to
have only a few favorite channels in the tuner's memory or you may want to delete from memory
a weak or unused channel that the tuner picked up.
• Erased channels cannot be selected by the up and down CHANNEL SELECT buttons but can
still be selected by using the numbered buttons 0 to 9 and 100/ENT.
Adding Channels
Occasionally the auto-programming may skip an active channel because the antenna was pointed
in the wrong direction or the channel had a weak signal or was "off the air" at the time of
programming or you may change your mind about a channel you removed from memory.
To Add or Erase Channels
• Press GUIDE, then press 5 to bring up the Initial Setup screen. Item 3 lets you add or delete
channels. Use the number buttons to enter the channel you want to change, then press STOP to
delete it or press PLAY to add it.
Caution After a Power Failure
If a power failure lasting for more than 30 minutes occurs, reset the clock and perform the "AUTO