Hitachi VT-M282A Portable DVD Player User Manual


 
Getting Started (Hookups)
15
Now continue wit the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the IN
FROM ANT. lower jack on the back of the VCR.
2. Using the 75 ohm cable supplied with your VCR, connect either end to the OUT TO TV upper
jack on the back of the VCR.
3. Use a second adapter to attach the other end of the 75 ohm connector back into the TV (where
you first disconnected the antenna).
Capabilities: With this hookup, you should now be able to perform all basic functions provided
by this equipment.
5 Attach the TV and VCR to the Power Supply
Plug in the TV and VCR power cords to the wall outlet or an appropriate extension cord or surge
protector. See Important Safeguards for further precautions (page 6).
6 Install Batteries in the Remote Control
The remote control requires two fresh "AA" batteries. On the back of the remote, a plastic cover
pushes off in the direction shown by the arrow. Remove this cover and install the batteries,
matching the plus end of each battery with the plus mark on the remote.
7 Set the RF or Video Channel Switch
When the VCR is on, its video signal can come into your TV an either channel 3 or channel 4.
You need to select the appropriate channel.
• Turn the power on to both the TV and the VCR, and look for a switch on the back of the VCR.
Set the switch to 3 or 4, whichever is not a commercial channel in your area.
Your basic hookup is now complete. When you're ready to try hooking up a second VCR or a
video camera, see Advanced Operations.
Now turn the TV and VCR back around facing you and begin your quick tour of the controls
(page 14).