Filter
Top Products
–
41
–
EN
2C15
English
CONTROLLING THE TV
Once programmed, the DVD’s remote control is
ready to control the TV.
NOTE: Be aware that not all of your TV’s functions
may work even though the remote control is
correctly programmed.
To operate the TV
¡You can turn on your TV by pressing the TV
POWER/STANDBY Button.
¡You can change the channels with the CH (K) or
CH (L) Button and the volumes with VOL ( ) or
VOL ( ) Button for the TV.
To operate the DVD
Press the VIDEO/TV Button to operate your DVD
with the remote.
PROGRAMMING THE REMOTE
CONTROL OF THE TV
1
Turn off the TV.
2 Program the remote control
Aim the DVD’s remote control at your TV set. Hold
down the TV POWER/STANDBY Button while you
press the number corresponding to your brand of tele-
vision as shown in the chart.
For example; If you have a Hitachi television, press
the TV POWER and 1 at the same time. If this
Button combination sends a signal that matches
with your TV, the TV will turn on, and you’ll know
the remote is set to control the television.
NOTES:
¡If that Button combination does not change the TV
channel, go through the whole list of Button com-
binations one by one until you find one that does
change your TV channel.
¡Also, if your brand of TV is not listed in the chart,
try all the number Buttons. One of them may work
for you.
¡If the TV channel still doesn’t change after going
through all the Button combinations listed, it is
likely that you will not be able to program this
remote control for your TV.
¡With some TVs, the VIDEO/TV Button may not
function.
REMOTE CONTROL OF THE TV
TV Brands Press the TV and This Number
HITACHI 1
SONY 2
RCA 3
SANYO 4
ZENITH 5
PANASONIC1 6
PANASONIC2 7
SHARP1 8
SHARP2 9
TOSHIBA 0
JVC CLEAR
MITUBISHI +10
MAGNAVOX SUBTITLE
FUNAI AUDIO
GOLDSTAR DISPLAY
H9210UD(EN)-2 02.4.15 10:18 AM Page 41