Filter
Top Products
ENGLISH
21
Connect power cable
Note:
Check that the mains voltage on the type plate (on the bottom of the
device) corresponds to your local mains supply. If this is not the case,
contact your specialist dealer.
1 Plug the mains cable into the socket (230 V~, 50/60 Hz).
Note:
The only way to disconnect the device from the mains supply is to pull
out the plug.
Connect projector
1 Plug the jack of the projector cable into the socket » « (left side of the
device) with the arrow pointing forwards.
PREPARATIONS____________________________________
M
NAP
WEC
AL 2
AL 1
PROJECTOR
ON/OFF
1/6
AL 2
AL 1
ON/OFF