Filter
Top Products
Connections
Antenna Connection
The clock radio comes with an FM wire antenna at the rear, please extend for best reception.
Power Source
The unit is powered by 230V~50Hz mains power supply. The 9V block battery (not supplied) is used for clock
back-up only. Please remove the battery during long periods of non-use to avoid battery leakage.
To avoid damages not covered by the warranty only connect the unit to above power supply.
Insert/Change Back-Up Battery
Insert the back-up battery in the battery compartment at the bottom of the unit. Please observe the polarity.
Change the back-up battery once a year.
Your settings (alarm, current time, etc.) are retained during power failure or when disconnecting from mains
power supply; the unit automatically switches to back-up battery.
Basic Operation
Turn Clock Radio On/Off
Turn the radio off with the VOL knob by turning it to AL position, when not in use. Turn the VOL knob to turn
the radio on and to adjust the volume.
Set the function selector to ON position.
Select the mode with the source selector, toggle between FM, AM and USB.
After use, please turn the unit off. To save energy, please disconnect the unit from mains power supply when
not in use for a long period of time.
In all modes the current time is displayed.
The unit is designed for continuous operation; it is either in ON mode or in standby mode.
Set Current Time
When first connecting the unit 0:00 flashes on the display.
Press and hold the TIME button and simultaneously press HOUR to set the hours in 24-hour mode.
Press and hold the button for fast setting or tap it briefly to increase the setting by one hour.
Now set the minutes with TIME (press and hold) and MIN.
Press and hold the button for fast setting or tap it briefly to increase the setting by one minute.
The current time is set.
Radio
Set the function selector to ON position. Select the mode with the source selector between FM and AM.
Turn the TUNING control to tune into your favorite station.
Turn the VOL knob to adjust the volume
Set the function selector to OFF position to turn the radio off.
The radio comes with an FM wire antenna; please unwind for best reception. For best AM reception please
direct the radio.
Playback via USB Port
1. Connect your portable MP3 player or memory stick via USB cable or directly to the USB port at the rear of
the unit.
2. Set the mode with the source selector to USB position.
3. Press to play music saved on your USB device.
4. Press or to skip forward or back to the next or previous track.
13.