Filter
Top Products
Selecting Power Levels
The front-mounted selector switch is used to
set the appropriate power level or impedance
for your system. Using a small, flat-blade
screwdriver, turn the knob until the slot points
to the power level you require.
70V/100V Systems
Both power setting scales for 70V and 100V
systems are labeled on the speakers. On the
100V scale, the last position clockwise is marked
with a symbol. Do not use this position in
100V systems.
16-ohm Systems
The fully counterclockwise position of the setting switch is the 16-ohm position.This
setting is suitable for use with low-impedance amplifiers that typically support 4- or
8-ohm speakers.The speaker’s higher,16-ohm impedance makes it easier to combine
multiple speakers into series-parallel networks while keeping the total system
impedance at a level suitable for low-impedance amplifiers.
Speaker Grille Installation & Removal
Installation
The speaker grille fits tightly! Push the speaker grille
in until it can go no further. Then, slap around the
edge of the grille to seat the grille.The grille is prop-
erly seated when it is flush with the edge of the bezel.
Removal
Insert a pocketknife blade between the grille and the
bezel about
1
/4" deep and then gently pry the grille
upwards. Do this in multiple places around the
circumference of the grille to free the grille.
4