Filter
Top Products
20
Fans
The
3-Slot Desktop Chassis
includes temperature-triggered fans. When the temperature of the
chassis reaches 40° C, the two fans activate to cool the chassis. The fans’ operation can be tested
by holding the Alarm Reset Button down for 4 to 5 seconds. The fans will activate and then they
will turn off when the button is released. If the fans do not activate, contact Black Box. Fans are
not end-user replaceable.
The red Alarm Reset Button also functions as a Fan Test button. To verify fan functionality, hold
the button down for several seconds, the fans should engage. The fans will turn off when the
button is released.
Installing Management and Application Modules
SNMP Management Modules include two twisted pair ports, one for management and one
reserved for future use. The Management Module also features a DB-9 serial port, and
supports SNMP V1/V2c.
Installing Applications Modules
To install a module:
1.
Remove the blank bracket (if present) covering the slot where the module will be
installed. Black Box recommends installing blank brackets in unused module slots.
2.
Slide the module into the chassis using the card guides.
3.
Secure the module to the chassis by tightening the captive screw. (Refer to the
documentation shipped with the module for configuration information.)
In order to manage a Desktop Chassis, the SNMP Management Module needs to be installed
in the appropriate slot of the chassis.
•
Install the 3-Slot Desktop Chassis slot SNMP Management Module into the bottom
left slot.
NOTE
This slot is ONLY for the Management Module; do not install Application Modules such as
media conversion and mode conversion modules in this slot.