Black Box LMC5233A Portable Media Storage User Manual


 
13
LNK/ACT
FDX/COL
TEMP
PS
FAN A / FAN B
Glows green when a link is established on port.
Blinks green when data activity occurs.
Glows yellow when port is in Full-Duplex mode.
Blinks yellow when port is operating in Half-
Duplex mode and collisions occur.
Glows yellow when temperature of unit
surpasses a user-defined level.
Glows yellow when one power supply module
malfunctions.
Glows yellow when a fan malfunctions.
Installing the 6-Slot Rackmount/Desktop Chassis
Install the chassis first before installing any modules into a 6-Slot Rackmount/Desktop Chassis.
When installing the chassis, be sure to observe the following precautions to prevent electrical
or mechanical damage:
1.
Protect the chassis from exposure to sunlight and electrical or magnetic fields.
2.
Ensure that the equipment rack remains stable, even with the addition of the chassis and
its associated cabling.
To install a 6-Slot Rackmount/Desktop Chassis:
1.
Have four #10 screws and four clip nuts available (hardware may vary depending on
rack type). The rest of the hardware is supplied with the unit.
2.
Locate a suitable location in the rack for installation and secure the clip-nuts onto the
mounting rails. Use screws to attach the chassis to the rack.
3.
Plug the chassis into a reliable, filtered power source.
4. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly,
the operating ambient temperature of the rack environment may be greater
than room ambient. Therefore, consideration should be given to installing the
equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
5. Reduced Air Flow - Installation of the equipment in a rack should be such that
the amount of air flow required for safe operation of the equipment is not
compromised.
6. Mechanical Loading - Mounting of the equipment in the rack should be such
that a hazardous condition is not achieved due to uneven mechanical loading.
7. Circuit Overloading - Consideration should be given to the connection of the
equipment to the supply circuit and the effect that overloading of the circuits
might have on over current protection and supply wiring.