Filter
Top Products
15
in iView²) to the administrator. There are also two LED indicators on the SNMP Management
Module for fan failure.
The red Alarm Reset Button also functions as a Fan Test button. To verify fan functionality,
hold the button down for several seconds, the fans should engage. The fans will turn off
when the button is released.
SNMP Management Modules include two twisted pair ports, one for management and one
reserved for future use. The Management Module also features a DB-9 serial port, and
supports SNMP V1/V2c.
Installing Management and Application Modules
Installing Applications Modules
To install a module:
1.
Remove the blank bracket (if present) covering the slot where the module will be
installed. Black Box recommends installing blank brackets in unused module slots.
2.
Slide the module into the chassis using the card guides.
3.
Secure the module to the chassis by tightening the captive screw. (Refer to the
documentation shipped with the module for configuration information.)
4.
When installing modules observe ESD precautions, refer to the Electrostatic Discharge
Precautions section.
In order to manage a 6-Slot Rackmount/Desktop Chassis, the SNMP Management Module
needs to be installed in the appropriate slot of the chassis.
•
Install the 6-Slot Rackmount/Desktop Chassis into the first slot on the far left of the
chassis.
NOTE
This slot is ONLY for the Management Module; do not install Application Modules such as
media conversion and mode conversion modules into this slot.