Filter
Top Products
128-6813
11 of 14
-11-
b. Place the antenna at the preferred location on
the roof or trunk surface. If the vehicle is
equipped with a roof or trunk rack, the antenna
may have to be mounted off-center on the
surface. The magnet will secure the antenna in
the desired position.
c. Apply power to the Shuttle system as outlined
in the associated User Guide and obtain an
audio output. If no audio is heard, first check
the signal strength indicator located on the
bottom left corner of the display to ensure the
antenna is receiving an optimum signal. If
necessary, move the antenna to different
positions on the surface until an audio output
is heard. This is the desired antenna position
and should be marked with masking tape or by
another non-scratch method.
7. Mounting the Vehicle Antenna
The antenna should be placed on a relatively flat
surface on the vehicle exterior, preferably on the
roof (high point) or on the trunk (convertible). To
mount the antenna:
a. Plug the antenna into the SAT. (MAIN) connector
on the back of the cradle.
d. After determining the optimum position, turn off
Shuttle power, disconnect the power
adapter from the vehicle cigarette lighter
receptacle and disconnect the antenna cable.
SAT
ANTENNA
(TYPICAL)
+12 VDC
ADAPTER
SHUTTLE
(TYPICAL)