Filter
Top Products
POWER SOURCE
Using with batteries
Insert two AA size batteries (LR6 or MN1500 alkaline) according to
the “
” and “ ” marks on the bottom exterior correctly aligned.
Notes on batteries
• Insert batteries with correct polarity.
• Do not mix old batteries together with new ones or different types
of batteries.
• If the electrolyte inside the battery should leak, wipe the
contaminated parts in the battery compartment with a cloth and
replace the old batteries with new ones.
• When the unit is not to be used for a long period of time, remove the
batteries.
• Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable
(NICKEL-CADMIUM) batteries.
Notes on “ ”
• During playback (batteries are in use), “ ” is off.
• When the battery voltage level is low, “
” will display for
approx. 10 ~15 minutes, playback still continues in this period.
• Playback would automatically come to a stop when the batteries
have no more power. Replace all the batteries with new ones.
• “
” would not be on if an AC adaptor is used.
Using on house current
If the unit you purchased does not include an AC power adaptor,
please use a 6V 350mA AC power adaptor. Plus pole “
” to the
centre pin of the 3.5mm socket.
When the unit is not to be used, be sure to disconnect the AC power
adaptor.
Portable MP3 CD Player
Operating Instructions
Before operating the unit, please read this manual thoroughly and
retain it for future reference.
CAUTION
The use of optical instruments with this product will increase eye
hazard.
INFORMATION (For the customers in USA)
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, If not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet that is on a circuit different
from the one the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for
help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
For the Customers in the United Kingdom / European
countries
This Compact Disc player is classified as a CLASS 1 LASER product.
The CLASS LASER PRODUCT label is located on the bottom exterior.
For the Customers in Canada
This apparatus complies with the
Class B limits for radio noise
emissions set out in radio
interference regulations.
This product contains a low power
laser device.
PRECAUTIONS
On safety
As the laser beam used in this compact disc player may be harmful
to the eyes, do not attempt to disassemble the casing. Refer servicing
to qualified personnel only.
Do not put any foreign objects in the safety slot inside the disc
compartment. If you do so, the laser beam may come out when the lid
is opened.
Do not put any foreign objects in the DC in 6V (external power input)
jack. Should any solid objects or liquid fall into the unit, disconnect the
power supply and have the unit checked by qualified personnel
before operating it any further.
On operation
Since the CD system offers a wide dynamic range, the peaks of the
high level inputs are recorded with high fidelity, and the noise level is
very low. Do not turn up the volume while listening to a part
of the disc with no audio signals or very low level inputs. If
you do so, the speakers may be damaged when the peak level of the
sound is played. The lens on the disc table should be kept clean. Do
not touch the lens or poke at it. If you do so, the lens may be damaged
and the unit will not operate properly.
Notes:
• The normal function of the product may be disturbed by
interference and shows error message, just reconnect the
power source for resume normal operation.
• The CD player and adaptor shall not be exposed to dripping or
splashing water and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
On installation
Never install the unit where it would be subject to:
- heat sources such as radiators or airducts.
- direct sunlight.
- excessive dust.
- moisture or rain.
- mechanical vibration or shock.
- uneven surface.
• Do not place any heavy object on top of the unit.
• When the unit is used with an AC power adaptor, do not wrap
the unit in a cloth, blanket, etc. If you do so, the temperature
inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit or serious accidents.
• If the unit is brought directly from a cold to a warm location, or is
placed in a very damp room, moisture may condense on the lens
inside the unit. Should this occur, the unit will not operate. In this
case, remove the disc and leave the unit in a warm place for
several hours until the moisture evaporates.
• For the unit to operate at its best, it should not be subject to
temperatures below 5
o
C (41
o
F) or above 35
o
C (95
o
F).
Notes on headphones / earphones
Do not use headphones / earphones while driving, cycling, or operating
any motorized vehicle, it may create a traffic hazard and is illegal in
some areas. It can also be potentially dangerous to play your headsets
at high volume while walking, especially at pedestrian crossings.
You should exercise extreme caution or discontinue use in potentially
hazardous situations.
Avoid using headphones / earphone at high volume. Hearing experts
advise against continuous, loud and extended play. If you
experience a ringing in your ears, reduce volume or discontinue use.
Keep the volume at a moderate level. This will allow you to hear
outside sounds and to be considerate to the people around you.
If you have any questions or problems concerning your unit, please
consult your nearest dealer.
Notes:
• This unit can play Audio Discs including CD-Recordables and CD-
Rewriteables. Do not try to play CD-ROMs, CD-ls, CDVs, or
computer CDs.
• The unit may not play a CD-R/RW disc that is recorded on
personal computers or some kinds of CD-R/RW recorders
because of differences in recording platforms.
• Do not attach any seal or label to either side(the recordable side
or the labled side) of a CD-R/RW disc. It may cause malfunction.
• Do not use irregular shape CDs(example: heart-shaped, octagonal
ones). It may result in malfunction.
• When a CD-RW is loaded, it takes about 15 seconds before it can
be play-back.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, THE CD
PLAYER AND AC/DC ADAPTOR DO NOT EXPOSE TO
RAIN OR MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE
CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
1. Read Instructions - All the safety and operating instructions
should be read before the appliance is operated.
2. Retain Instructions - The safety and operating instructions
should be retained for future reference.
3. Heed Warnings - All warnings on the appliance and in the
operating instructions should be adhered to.
4. Follow Instructions - All operating and use instructions should
be followed.
5. Water and Moisture - The appliance should not be used near
water - for example, near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement, or near a swimming pool, etc.
6. Ventilation - The appliance should be situated so that its location
or position does not interfere with its proper ventilation. For
example, the appliance should not be situated on a bed, sofa,
rug, or similar surface that may block the ventilation openings;
or, placed in a built-in installation, such as a book case or cabinet,
that may impede the flow of air through the ventilation openings.
7. Heat - The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
8. Power Sources - The appliance should be connected to a
power supply only of the type described in the operating
instructions or as marked on the appliance.
9. Grounding or Polarization - Precautions should be taken so
that the grounding or polarization means of an appliance are not
defeated.
10.Power-Cord Protection - Power-supply cords should be
routed so that they are not likely to be walked on or pinched by
items placed upon or against them, paying particular attention to
cords at plugs, convenience receptacles, and the point where
they exit from the appliance.
11.Cleaning - The appliance should be cleaned only as
recommended by the manufacturer.
12.Nonuse Periods - The power cord of the appliance should be
unplugged from the outlet when left unused for a long period of
time.
13.Object and Liquid Entry - Care should be taken so that objects
do not fall, and liquids are not spilled into the enclosure through
openings.
14.Damage Requiring Service - The appliance should be
serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged; or
B. Objects have fallen, or liquid has been spilled into the appliance;or
C. The appliance has been exposed to rain; or
D. The appliance does not appear to operate normally or exhibits
a marked change in performance; or
E. The appliance has been dropped, or the enclosure damaged.
15.Servicing - The user should not attempt to service the appliance
beyond that described in the operating instructions. All other
servicing should be referred to qualified service personnel.
PLAY MODE
PROGRAM
OPEN
SKIP
PLAY/PAUSE
PHONES
Main Socket
VOL
SKIP
STOP
EQ
ESP ON/OFF
DIR
FUNCTION OF CONTROLS
PLAY MODE BUTTON
It changes playing mode as
follows:
Repeat One ->
Repeat All ->
INTRO ->
SHUFF ->
SHUFF All ->
PROGRAM BUTTON
It reserves songs to play in the
program play mode.
EQ BUTTON
It changes EQ mode in play
mode as below:
Normal -> Bass -> Train -> Live
-> POP -> Jazz
STOP BUTTON
It activates stop mode from
playing mode, activates
standby mode.
It clears all program memory in
the program mode.
SKIP/SEARCH BUTTON
It activates skip to previous
track (or directory) and acti-
vates high-speed reverse
search.
VOLUME BUTTONS
Adjust the volume.
ESP ON/OFF BUTTON (For CD
playback only)
It activates/deactivates ESP func-
tions by pressing ESP ON/OFF
button. (Prevent sound skipping)
DIR
To search a file by directory
level for MP3 disc.
Main Socket
DC IN 6V. For connecting the AC
adaptor.
PHONES JACK
For connecting the headphones
/ earphones.
PLAY/PAUSE BUTTON
It release standby mode,
playing starts from stop mode.
It toggles playing and pause.
SKIP/SEARCH BUTTON
It activates skip to next track (or
directory) and activates high-
speed forward search.
OPEN KNOB
For opening the CD door.
DISC PLAYING
1. Open the CD door with the “ OPEN ” knob.
2. Insert the CD with the printed side facing upwards and push the
disc gently until it clicks so that the disc fits into the pivot.
3. Press the CD door to close.
4. Press the “ ” button to play.
On display windows
When you press “ ” , the display window shows:
During play
The track number of the current selection appears.
When “ ” is pressed during play, total number of tracks on the disc
will be displayed and the unit is still on. The unit will return to full stop
mode automatically after approximately 30 seconds if no button is
pressed again. Or press “ ” button to stop the unit.
IMPORTANT SAFETY INSTRUCTIONS
DO NOT TOUCH THE LENS
CAUTION: INVISIBLE LASER
RADIATION WHEN OPEN AND
INTER LOCKS DEFEATED
AVOID EXPOSURE TO BEAM
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
PRODUTO LASER CLASSE 1
Note: The key tone will be heard while pressing the function buttons.