AAMP of America Simple iPod Interface for BMW MP3 Docking Station User Manual


 
TOP VIEW
1 2
3
4
5
6
7
8
DIP
ON
DIN CONNECTOR / DIP SWITCH VIEW
22-PIN HARNESS VIEW
1.3 Programming the iSimple BMW Interface
Now that you have identied the correct harness and dip-switch conguration us-
ing the application guide, it is now time to program the interface.
To program the interface, set the dip-switches located on the side of the interface
(see Fig.1 below) to the congguration listed below. Switches are in their default
setting of “off” in the up position and are turned “on” when switched down. Refer to
the chart on the bottom of this page.
This programs the iSimple BMW interface to the vehicle it is being installed in. The
dip-switches MUST be set before the interface is plugged into the vehicle. Otherwise
the iSimple BMW interface will not work correctly.
Dip Switch Conguration Chart
Fig.1 Side view of Interface with dip switches
2
iSimple BMW interface
Docking cable
Vehicle specic harness
BRAND
BMW
MODE
CDC or
Changer
HARNESS
Vehicle
specic
harness
1 2 3 4 5 6 7 8
OFF OFF ON ON OFF OFF OFF ON